Very Bes, flowable dental restorative composite, Dentstal

Description Very Bes, flowable dental restorative composite, Dentstal

DESCRIPTION:

• The composite is fluid and well polished, 67% filled with photopolymer composite with application, rarity and esthetics characteristics that most dentists provide.

SCOPE OF APPLICATION:

• Dentistry. Dental treatment of carious or other damage to the teeth, accompanied by their treatment.

MODE OF APPLICATION:

• Fluid Composite is ideal for Class III, Small Class IV and Class V cavities to prevent resin restorations, to correct small defects and to fill in sockets caused by toothbrushing and receding gums. It is also used to eliminate notches before composite bonding of internal inlays and to repair cracks and fill in restricted areas in front of thickened composite.

Bonding to dentine

• Isolate, clean and prepare the tooth socket. If necessary, apply base/gasket in deep recesses.
• Etch the dentine with 37% etch gel for 15 seconds.
• Rinse thoroughly.
• Keep this surface clean, avoiding saliva.
• Rapid bond strength is achieved by applying a one-component photopolymer dentin-enamel bonding to the etched surface.
• Carefully follow the instructions for using the one-component photopolymer dentine-enamel bonding.
• Choose the right tone.
• Connect the needle applicator to the syringe and start pouring the material.
• Apply along proximal and ash edges. Using the needle applicator, place the composite into small depressions.
• Do not apply a layer deeper than 2-3 mm.
• Illuminate the photopolymer lamp for 30 seconds. Finish with standard bur and polish.

Bonding to enamel

• Clean the enamel surface with a fat-free cleaning paste. Rinse thoroughly and dry.
  
• Isolate the surface from saliva.
• Etch the dentine with 37% etch gel for 15 seconds. Rinse completely.
• Dry the etched surface with clean air. Do not blow saliva onto the etched surface. If the etched surface does not look like white chalk, repeat the etching again.
• Apply one-component photopolymer dentin-enamel bonding to the etched enamel.
• Carefully follow the instructions for using the one-component photopolymer dentine-enamel bonding.
• Connect the needle applicator to the syringe and start applying the material.
• Apply liquid photopolymer composite to the enamel.
• Illuminate the photopolymer lamp for 30 seconds. Finish with standard bur and polish.

WARNING AND WARNING:

• The composite contains certain methacrylates and other substances that may cause irritation or sensitivity in some individuals.
• In case of contact with skin, wash immediately with soap and water. Improper use may result in an allergic reaction, irritation of the skin and other tissues. If this happens, stop using the product. Protective gloves and goggles should be worn when using this product.
• In case of contact with eyes, rinse with plenty of water and seek medical attention immediately.
• Avoid contact of the etching solution with oral soft tissues, eyes and skin. In case of accidental contact, rinse immediately with plenty of water.
• Do not use material at elevated temperatures or intense light.
• Do not store the product near eugenol based materials.
• Make sure the caps on the syringe and bonding agents are closed immediately after use to prevent premature polymerization by exposure to natural light.
• Storage: store at temperatures from +3 to +24°C.
• Shelf life - 3 years.

EQUIPMENT:

• Syringe - 1 piece, 2 g.